The frame and rear bearing carrier were taken to Electro Tech Coatings in Escondido, CA for powder coating. These folks are very cool. When I 1st brought them the frame and bearing carrier, I told them I wanted to get the frame sand blasted so I could haul it to the Banister Iron Works for the A-arm conversion kit installation and then return it for coating. Not a problem. They called me the day after I dropped it off and said it was ready to go. Nice! A couple days at Banister Iron Works and I brought the frame back to Electro Tech. 3 days later it was done. These pics were taken not 30 seconds after I pulled the parts from the truck and about 10 minutes from getting the frame up on stands and prepping the engine mount hardware.